The functionality provided by the controller does not change, except for customers who have Layer 2 deployments, which CAPWAP Deployments can combine CAPWAP and LWAPP software on the controllers. LWAPP-enabled access points are compatible withĬAPWAP, and conversion to a CAPWAP controller is seamless. The Lightweight Access Point Protocol (LWAPP) used with the access points. The discovery process using CAPWAP is identical to CAPWAP is a standard, interoperable protocol that allows anĪccess controller to manage a collection of wireless termination points. The controller and other wireless access points on the network. The access point uses standard Control and Provisioning of Wireless Access Points Protocol (CAPWAP) to communicate between The default password is Cisco and is case-sensitive. EnteringĮn prompts you for a password, then takes you to the privileged exec mode. Pressing enter takes you to the user exec mode. When connected, press enter or type en to access the command prompt. Use the following settings for the terminal emulator connection:ĩ600 baud, 8 data bits, no parity, 1 stop bit, and no flow control. Set up a terminal emulator to communicate with the access point. The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Follow these steps to open the CLI by connecting to the accessĬonnect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the access point and to the COM port onĪ computer. PC to its console port using a DB-9 to RJ-45 serial cable. If you need to configure the access point locally (without connecting the access point to a wired LAN), you can connect a IOx Configuration on AireOS Controller (WLC/ME)Ĭisco Catalyst IW6300 Heavy Duty Series and 6300 Series Embedded Services Access Point.Mesh Configuration for AireOS/ME Controller.RAP Ethernet Daisy Chain Redundancy for STP Ring Topology.Checking ssid-broadcast-persist Status From IOS-XE WLC Controller.Mesh Configuration From IOS-XE WLC Controller.Mesh Configuration From AireOS WLC or ME Controller.Checking LAN Port Status from Controller and AP.Uplink Selection for Bridge/Flex+Bridge Mode.Changing an Bridge AP Role From IOS-XE WLC.Changing an Bridge AP Role From AireOS WLC. Adding the Access Point MAC Addresses to the Controller Filter List.Performing a Pre-Installation Configuration.Connecting to the Access Point Console Port.Configuring the Access Point for the First Time.Cisco Catalyst IW6300 Heavy Duty Series and 6300 Series Embedded Services Access Point.
0 Comments
Leave a Reply. |